Niko-Servodan Intelligenta bygginstallationer

Digital black is a completely customisable control screen for Niko Home Control with an extremely user-friendly interface featuring clear symbols. The screen is automatically activated when your hand comes near. That way, you can switch or dim your lights, set scenarios, set ventilation modes, adjust blinds and sun blinds to the wanted position, in one operation. In short, all possible Niko Home Control control types are available.

The push-button interface converts a switching pulse from an external push button into a Niko Home Control bus command. The interface has four inputs for the connection of a maximum of four potential-free NO or NPN inputs. The output is connected to Niko Home Control and can also be interconnected to the next control element.

Single flush surround plate from the range Niko Intense. Finishing colour flush surround plate: Intense white.

This switching module is used to switch six different circuits, for example, light points, socket outlets or control valves. By pushing the button, you can also control each contact manually. Using this module, you can interconnect two zero conductors, this keeps the wiring in the electricity cabinet tidy. The module is equipped with six feedback LEDs and one status LED and uses very little energy.

· Maximum load of 6A/250 V· Loop terminals· Relay status via LED· Small dimensions

This push button allows you to perform four operations. It is attached to the wall-mounted printed circuit board via a click mechanism. Switch including button. Finishing colour: white.

This module allows you to control the heating or cooling in a maximum of four separate zones or rooms. Each zone or room should be equipped with a Niko Home Control thermostat. By pushing the button, you can also control each contact manually. The module includes five indication LEDs and one status LED, and uses very little energy.

Used with presence detectors 41-75x, 41-76x and 41-78x DALI

With this module, you can control three motor-controlled applications, such as roller blinds, curtains or awnings, for example. By pushing the button, you can also control each motor manually. The run time of the motors can be set with the programming software. Using this module, you can interconnect two zero conductors, this keeps the wiring in the electricity cabinet tidy. The module is equipped with six feedback LEDs and one status LED and uses very little energy.

This motion detector is suitable for outdoor use, for example, along the driveway, on the terrace or in the garden. It is also equipped with a built-in light sensor. You aim the motion detector wherever you wish and partition the detection area using a cover mask. The Niko Home Control system supplies power to the device. Finishing colour: white

The connected controller is the central module of every Niko Home Control installation. It covers all basic functions on which a Niko Home Control installation is built: it provides the power supply to the bus, ensures the connection with Niko Home Control IP devices (touchscreens and external video units) and enables remote control with a smartphone or tablet. Per installation only one connected controller is necessary. This module contains firmware that can only be programmed with the Niko Home Control programming software 2.1.1 or higher.

Used with presence detectors 41-75x, 41-76x and 41-78x DALI

This module must always be positioned as the first module on the left at the beginning of a new row of DIN rail modules. The power supply and the bus are connected to the previous rail and/or to the next rail from the rail coupling or power supply module via the contacts on the top and bottom sides.

· 230 V AC· Flush mounted in the ceiling· Use together with Master type 41-65x· Extends the detection area to all Masters type 41-65x· Plug & Play - no programming· Rapid and flexible installation with DALI addressable bus· Supply voltage via the DALI bus· Standby consumption < 0,1 W· Prodtection class IP20