Danfoss Komponenter för switchboxar och skåp

DEVIreg TM 330 is a series of simple electronic thermostats for installation in cabinets withDIN rail bracket. To measure and control the desired temperature, either one must be usedwiring sensor (in the kit) or an external or space sensor. The thermostat must be installedafter a multi-pole switch. It has an LED indicator that shows standby periods (green light) andheating periods (red light).DEVIreg TM 330 has a relay with two contact pairs - NO (normally open) and NC (normally closed) andis intended to be used for heating and cooling systems. In addition, the NO and NC contact pairsnot supplied by a voltage source inside the thermostats and can be used forcontrol systems with any voltage up to 250 V.The series is designed with thermostats in three temperature ranges.DEVIreg TM 330 (-10 - +10 ° C) is primarily used to control a lower temperature range such asantifreeze. This thermostat has a knob for adjusting the temperature setting with a scalefrom -10 to +10 ° C. Special outdoor wire with white wire, 2,5m, is included in a set.

DEVIreg TM 316 is a simple, electronic thermostat with enhanced installation functionalityin cabinets with DIN rail fittings. The thermostat is primarily used for frost protection on roofs, igutters and downpipes. In addition, it can be used to control room and floor temperature,ventilation, cooling or snowmelt on the ground, pipe fencing and similar installations.The primary characteristics of the thermostat are the temperature setting range - with setting ofboth an upper and lower temperature, between which the thermostat allows the system to heat.This mode is primarily used to control frost protection systems on roofs, gutters anddownpipe (an external outdoor air sensor must be used).The thermostat is equipped with two additional buttons for adjusting the hysteresis andthe temperature value for use during economy periods (an external timer is required).The thermostat has a relay with two contact pairs - NO (normally open) and NC (normally closed), and it is intended to use the thermostat for heat andcooling systems. In addition, the NO and NC contact pairs are not powered by a voltage source within the thermostat and can be used forcontrol systems with any voltage up to 250 V. It is designed so that the sensor circuit is galvanically separated from the high voltage part.

DEVIreg TM 330 is a series of simple electronic thermostats for installation in cabinets withDIN rail bracket. To measure and control the desired temperature, either one must be usedwiring sensor (in the kit) or an external or space sensor. The thermostat must be installedafter a multi-pole switch. It has an LED indicator that shows standby periods (green light) andheating periods (red light).DEVIreg TM 330 has a relay with two contact pairs - NO (normally open) and NC (normally closed) andis intended to be used for heating and cooling systems. In addition, the NO and NC contact pairsnot supplied by a voltage source inside the thermostats and can be used forcontrol systems with any voltage up to 250 V.The series is designed with thermostats in three temperature ranges.DEVIreg TM 330 (5-45 ° C) is primarily used for controlling a lower temperature range, such as frost protection, as well as for cooling, comfort floor heating, total (direct)underfloor heating, ice and snowmelt on the ground, frost protection on roofs, pipe protection etc. The thermostat has a button for adjusting the temperature setting with ascale from 5 ° C to 45 ° C. This type has temperature drop in economy period mode using an external timer.