Touch Board
The Touch Board is an easy-to-use platform for a huge range of projects. Combine the Touch Board and Bare Conductive Paint and you can turn almost any material or surface into a capacitive or proximity sensor. You could paint a light switch on your wall, make a paper piano or trigger a sound via the onboard MP3 player. The number of touch-activated projects enabled by combining Touch Board with Electric Paint is only limited by the imagination.
Touch Board is an Arduino Shield-compatible processor board with extra features such as the 12-channel touch/proximity interface and an MP3 player. It appears as an Arduino Leonardo to the Arduino IDE for programming purposes.
ATMega32u4 16 MHz microcontroller, 32 KB Flash memory, 2.5 KB SRAM, 1 KB EEPROM
Bootloader uses 4 KB of Flash memory
MPR121 12-channel touch interface
VS1053B multi-format audio CODEC
Arduino Rev 3 Shield compatible (check pins available)
20 x GPIO pins maximum
7 x PWM channels
12 x analogue input channels
12 x Touch electrodes of which 8 can be configured as extra GPIO with PWM capability
Power supply: +5 Vdc (automatic voltage selector for USB or battery operation)
Built in LiPo battery charger with status LED
microSD card slot
3.5 mm audio out jack socket
microUSB socket
External power socket
Reset pushbutton
Power slide switch
Dimensions: 84 x 62 x 10 mm
Arduino compatible (recognised as an Arduino Leonardo in IDE)
Getting Started guide available online at: http://www.bareconductive.com/make/introducing-the-touch-board/
Ovanstående information och specifikationer är vägledande och kan utan förvarning ändras av producenten. Alla uppgifter lämnas med reservation för tryckfel, och bilder är vägledande. Vissa texter kan vara autogenererade eller maskinöversatta och kan därför ge texter som kan vara missvisande.